The Benefits Of Using Alexandrite And Nd: YAG Laser
http://www.womensquarter.com/articles/12123/1/The-Benefits-Of-Using-Alexandrite-And-Nd-YAG-Laser/Page1.html
John Chambers
As a person looking for laser hair removal sydney you should visit that site. Learn more on the topic of ipl hair removal sydney. By John Chambers
Published on 23 November 2011
Using medical treatments with Melanin may somehow cause more tincture on light shaded hairs. Before laser treatments, it is recommended that a patient would constantly apply topical Melanin containing solution since it caters to the overall efficacy of the laser treatment after some time.
Melanin is the main ingredient used on the hair that is light in color, to enrich its pigment. Once there is an applied topical solution on the areas that will be lasered after some time, there is a more chance of having the laser treatment done successfully.
Ten patients who have either blonde, or white facial hairs have been tested to apply the solutions containing Melanin before they undergo laser treatments, and all these are observed within a few weeks of application.
Dual long pulse lasers were made use of here and they were used on the face of the subjects. A schedule of three times was performed for each month to undergo the laser procedure and the mixture of both topical pretreatments and laser treatments went out fine.
Follow up visits were done by patients for duration of one month after all the three treatments were done and performed. Delivering an acceptable but slightly lower reduction percentage of 49 in this case was the ND:yag laser variety.
It has remained to be a challenging task to completely remove hair that is light shaded in general, even if there were advanced laser procedures created. Comparing the effectiveness rate of the laser procedures being tested in clinical centers, Europe has a bigger percentage for hair reduction than Washington.
The outcomes are considered to be temporary and unpredictable since there is a continuous study regarding the condition of the patients. There must be further studies done on how such treatments react on a long term basis, with regards to both positive and negative effects.
Within the liposomes, melanin is the main component that is found on this particular topical product. There is a required application of the topical treatments for two times in a day, and it has to begin before actual laser system treatments.
Four times application on the affected area are needed and you need to have the treated area dry off first before doing the next application until the last.
Many patients opposed on the use of this particular product despite the safety measures it entailed. Another important issue to consider is how patients would react on the product.
There should be a wider cover of study done on how the topical treatments work and benefit the patient into catering a longer period of time for hair growth elimination.
One needs to be at least 44 years old to be able to join the study conducted for the use of the melanin solutions application before laser treatments.
The pulse rate of alexandrite laser treatment is 3msec, and it has a spot size of 18mm, with a fluence level of 20 J/cm2 and these numbers are totally significant in the kind of study that was conducted on the willing patients in this case.
The pulse rate of Nd: YAG Laser treatment is 10 msec, and it has a spot size of 10mm, with a fluence level of 60 J/cm2, and there should be specific ways on coming up with all these parameters so that it will be easier for the professionals using the technology to identify potential purposes for it.
Ten patients who have either blonde, or white facial hairs have been tested to apply the solutions containing Melanin before they undergo laser treatments, and all these are observed within a few weeks of application.
Dual long pulse lasers were made use of here and they were used on the face of the subjects. A schedule of three times was performed for each month to undergo the laser procedure and the mixture of both topical pretreatments and laser treatments went out fine.
Follow up visits were done by patients for duration of one month after all the three treatments were done and performed. Delivering an acceptable but slightly lower reduction percentage of 49 in this case was the ND:yag laser variety.
It has remained to be a challenging task to completely remove hair that is light shaded in general, even if there were advanced laser procedures created. Comparing the effectiveness rate of the laser procedures being tested in clinical centers, Europe has a bigger percentage for hair reduction than Washington.
The outcomes are considered to be temporary and unpredictable since there is a continuous study regarding the condition of the patients. There must be further studies done on how such treatments react on a long term basis, with regards to both positive and negative effects.
Within the liposomes, melanin is the main component that is found on this particular topical product. There is a required application of the topical treatments for two times in a day, and it has to begin before actual laser system treatments.
Four times application on the affected area are needed and you need to have the treated area dry off first before doing the next application until the last.
Many patients opposed on the use of this particular product despite the safety measures it entailed. Another important issue to consider is how patients would react on the product.
There should be a wider cover of study done on how the topical treatments work and benefit the patient into catering a longer period of time for hair growth elimination.
One needs to be at least 44 years old to be able to join the study conducted for the use of the melanin solutions application before laser treatments.
The pulse rate of alexandrite laser treatment is 3msec, and it has a spot size of 18mm, with a fluence level of 20 J/cm2 and these numbers are totally significant in the kind of study that was conducted on the willing patients in this case.
The pulse rate of Nd: YAG Laser treatment is 10 msec, and it has a spot size of 10mm, with a fluence level of 60 J/cm2, and there should be specific ways on coming up with all these parameters so that it will be easier for the professionals using the technology to identify potential purposes for it.